Wind boost

**Islandnomad** · 22nd July 2015, 10:04 AM

Thanks. The Madman EMS1 seems to get a good wrap on here, looks pretty expensive though once you buy all the sensors and float thingy's and then install it all, but the more information you have the better from my readings here.

I also have a Nanocom and you can buy a mount for them, but it's instrument setting doesn't tell you much? Maybe I'm not using it properly?

**Islandnomad** · 22nd July 2015, 10:09 AM

I have now also been reading on here that the Bruce Davis remapps can run hot....which is a bit of a worry. I'm a very conservative driver though.

I really don't want to damage this motor, maybe I should take it back to standard LR mapping?

**discorevy** · 22nd July 2015, 05:45 PM

Fit an egt sensor and gauge , this will take the worry out of it

Tombie · 22nd July 2015, 05:49 PM

Stop worrying and put an EGT gauge in

**Islandnomad** · 22nd July 2015, 06:00 PM

Well I've looked into it $ wise:
Madman EM1 is $232 plus a D2 Sender Kit $192 plus del. from distributer in AUS (was significantly cheaper than direct from S.A.). Would also save me buying the Enginesaver at $161, if this system does the same thing/or is just as good, but I'm not sure.

Bruce Davis D2 Chip Upgrade is normally $1000 currently discounted to $800. A lot to throw away if its good!?

The Madman system seems pretty well regarded on here, and I could learn a lot more about my car with it.

Seems like a plan?

10,000 Posts Tombie! Congratulations!!!