Thread: What happened to your Discovery 2 today?

Originally Posted by Roverlord off road spares

John looking at your package of bolts, are there also 2 plates for extending the height sensors? doesn't look like there is in pic. The kits we have sold have a plate that extended the height sensors by the height of the spacers,
Cheers, Mario

There may be a small chance that I forgot that you sold these Mario. Sorry. At least I kept my money in Australia!

At the moment my bags are lifted by 40mm to match my front OME suspension. Problem is, when I go into raised height mode I'm concerned about over 'stretching' the bags. So I was just going to add these and leave the existing heights as is. I asked this question in another thread, general consensus was that that this will be ok without extending the height sensors. Otherwise I'll make up some height sensor raisers. Another factor to consider is that I have standard OME shocks which really aren't that much better than standard length. I figured if I have issues I'll get longer shocks, then I'll have to raise the height sensors also.

If you want the current bag position to remain unchanged with the spacers in, the angle of the sensor arm must remain the same. Hence the sensor extensions.

Originally Posted by biggin

If you want the current bag position to remain unchanged with the spacers in, the angle of the sensor arm must remain the same. Hence the sensor extensions.

And he already has it adjusted 40mm so when the spacer is fitted it will adjust and vehicle will remain the same height (just with the bag 40mm shorter).

I washed it in preparation for wedding duties!

and the room went deathly quiet------





yours ? he asked hesitantly--

Negative Ghost Rider.
Katherine's sisters

Originally Posted by Disco Muppet

Negative Ghost Rider.
Katherine's sisters

The pattern is full....

Yesterday actually mine had a 250 k service. Murray at Jag Rover gave it a going over and there was nothing major to worry about at the moment. He said it would be a good idea to do his thermostat mod to it and it will need a new ball joint on the front and seal in the not too distant future. I have a diesel leak when I fill the tank to the top. I will have to check that out.
So all in all a good result.
Cheers,
Russ