Thread: Performance chips> Are they worth the money???

Originally Posted by Dorko

weird... my email is roy@rdmconsulting.com.au

I'll email you the install guide.

Originally Posted by Chip It

I'll email you the install guide.

Can you explain to me the Dyno test between the Stienbaur/chip-it and standard Disco 3

It says the std Disco 3 has 822.9 Nm of torque or am I reading it wrong??

As far as I'm aware the 2.7 TDV6 only has 440Nm.

Baz.

Interesting to know what it does cost for a 2.7 as for price it may be more than a re-map with a module?

I cannot see any advantage over a re-map.

Originally Posted by CaverD3

Interesting to know what it does cost for a 2.7 as for price it may be more than a re-map with a module?

I cannot see any advantage over a re-map.

According to the Chip-it website, it's $1299 for the Chip with an EGT monitor and $899 for the standard Chip.

These are the figures of a supposed 10% increase in power

Scroll down for the prices
http://www.chipit.com.au/chipped_veh...cles/landrover

Bluefin module where you can put it on and off is 455 UK pounds:

http://www.mybluefin.co.uk/search'ma...73&variant=212

Gives simailar results:

http://www.mybluefin.co.uk/curves/landrovertdv6.pdf

Cannot see the point in adding on a module especially if under warranty and it needs to come off sometimes.

Originally Posted by CaverD3

Bluefin module where you can put it on and off is 455 UK pounds:

http://www.mybluefin.co.uk/search'ma...73&variant=212

Gives simailar results:

http://www.mybluefin.co.uk/curves/landrovertdv6.pdf

Cannot see the point in adding on a module especially if under warranty and it needs to come off sometimes.

So those are HP and ft lbs not Nm and Kw in that Chip-it graph

Looks like it but I think those torque figures are telling porkies though.

Those tests were on a D4 3 litre , NOT a 2.7 D3 or D4. The Torque is useless junk and refers to "Tractive effort" So standard is 600nm on a D4 3L and they claim 822, so thats 222nm more So take the 933 and remove the 222 and you get 711 ,thats more like it .Now as for HP or Power ,that changes to HPM , whatever that is , and it goes from 194 to 247 or an increase of 25% , So, disregarding the silly numbers , (silly considered 180kw is 244Hp standard anyway)torque increased 20% and power 25% over whatever they started with.
For that money Id rather go the remap solution !!!