Thread: stage one trayback

The chassis is probably 2.5mm from memory, I think I just went to 3mm.

Having a close look at the old girl [bit more chassis rust than i first thought,never mind]there is an oil cooler on drivers side under radiator,cut out for it looks original.Pipes go nowhere,one is rusted out looks like they have gone nowhere for a while.Is this engine or transmission?And there is a reservoir behind the cab with one pipe leading to or from it.No filler visible.What is it for?Have not tracked pipe yet.

Originally Posted by rangietragic

Having a close look at the old girl [bit more chassis rust than i first thought,never mind]there is an oil cooler on drivers side under radiator,cut out for it looks original.Pipes go nowhere,one is rusted out looks like they have gone nowhere for a while.Is this engine or transmission?And there is a reservoir behind the cab with one pipe leading to or from it.No filler visible.What is it for?Have not tracked pipe yet.

hi shed full of chassi rails going cheap jim

Originally Posted by rangietragic

Having a close look at the old girl [bit more chassis rust than i first thought,never mind]there is an oil cooler on drivers side under radiator,cut out for it looks original.Pipes go nowhere,one is rusted out looks like they have gone nowhere for a while.Is this engine or transmission?And there is a reservoir behind the cab with one pipe leading to or from it.No filler visible.What is it for?Have not tracked pipe yet.

Most likely had some sort of hydraulic gear attached at some time - only reason I can see for a hydraulic reservoir. Perhaps a hydraulic winch, maybe a tipper. Could have been driven by a gearbox mounted pump or an engine mounted pump. The oil cooler alone could have been for the engine. Never heard of an oil cooler on that gearbox. It doesn't have a pump on a PTO on the back of the transfer case does it?

John

Originally Posted by JDNSW

Most likely had some sort of hydraulic gear attached at some time - only reason I can see for a hydraulic reservoir. Perhaps a hydraulic winch, maybe a tipper. Could have been driven by a gearbox mounted pump or an engine mounted pump. The oil cooler alone could have been for the engine. Never heard of an oil cooler on that gearbox. It doesn't have a pump on a PTO on the back of the transfer case does it?

John

No pump,i'll crawl under tomorrow and trace the line from that reservoir and see where it goes

Reservoir pipe leads to top of fuel tank.Fuel tank has no cross ribbing on sides.Looks all flat steel.Original?

Originally Posted by rangietragic

Found a bit of rust in the chassis.Have to plate it.What guage sheet should i use on chassis and bulkhead?I want to restore this properly.

The chassis is originally 2.4 mm. The bulkhead varies from 1 mm upwards.

I have used 3mm for chassis repairs and 1.2 or 1.6 mm for repairs to the bulkhead.

I was told the tank behind the cab is the expansion tank for the fuel tank..mine has the same thing..