Thread: What did you do on your Landy today?

Took some photos of the few little jobs I've been attending to over the last few weeks.....
2011-12-14 19.31.39.jpg.jpg2011-12-06 11.03.41.jpg2011-12-06 10.59.46.jpg2011-12-14 19.31.16.jpg.jpg
Airlocker in the back with new crownwheel and pinion with solid pinion bearing spacer, new stub axles, wheel bearings, brake cylinders,shoes, drive flanges,lower susp.arms, bushes and ball joint, longer shocks and raised shock mounts,fully rebuilt gearbox,(with centre dif, mainshaft and all the gears except 2 replaced) all new front suspension, bushes, front arms, adjustable panhard rod, new steering box, ball joints longer shock towers, stainless brake lines all round, and a fully recon motor........ just the odd bit of fettling!!!!!!

Originally Posted by DCPAus

I replaced every single coolant hose, and the Heater Matrix on my D2, what a lot of work!

Finished it all today, went for a drive and noticed still small leak on O Ring on Heater Matrix, but now I know what I am doing that will be a 30 minute job, then noticed that on one hose where I decided to reuse a silly Landrover clamp I have a leak, and ........ I forgot to put the Fan Shroud back in.

Luckily the annoying little leak would have needed the fan out anyway to get to it so no big deal about the fan shroud.

Although a really tiring experience it was worthwhile, as I took all the engine bay "bits and bobs" out and so was able to have a really good look at the engine bay. I now know that this rime next year I will replace the Oil Housing Cooler, and most probably the water pump (pitting on the outlets)

Frustrating that I have to do some pieces again tomorrow but the experience and confidence gained makes it all worthwhile.

THe annoying little leak that I still had, was because I had forgotten to tighten the hose clamp thta connect the radiator to the thermostat

And the leak in the matrix was a similar issue I hadn't adequately tightened the saddle clamp.

spent half the morning chasing up a clutch release bearing, then came home after work and pulled out the old spigot bearing housing.

I think I owe IsuzuBob a beer or three for this piece of advice......
http://www.aulro.com/afvb/projects-t...g-housing.html
Worked a treat, Cheers Bob!

Finish fitting the front diff guard, a steering guard and looking for where the ???? is this leak coming from?

Finish fitting the front diff guard, a steering guard and looking for where the ???? is this leak coming from?

Part 2

Completed auxiliary battery install in #2 son's D2a. Sorted (I think/hope!)RRC Roger's temperemental cruise control and put the dash back together.

Now having nanna nap!

Pete

Drove it 300km, without any problems at all. Stoked to be back on the road

Originally Posted by isuzutoo-eh

Drove it 300km, without any problems at all. Stoked to be back on the road

Great news to hear that the 'Lumbering Giant' - and also 'isuzutoo-eh' - are back on the road again.

I wouldn't mind having a look at the new reinforcing - will you be dining at The Ranch for lunch on Tuesday?