Thread: What did you do on your Landy today?

Replaced a uni joint and put the tailshaft back on. Drives well no vibes or squeaks so that's enough till the upgrade arrives.
Repco home branded unis are about $27, cheaper than the ebay options I could find.

New heavy duty axles, HD steering drag link and track rod and new front prop shaft = $1297 plus a bit for labour. I'm also installing the compressor for an ARB air locker and I need to wire up to the positive terminal on the accessories circuit on the ignition switch and also the dashboard illumination circuit - does anyone have any pics of these?
cheers Gerald

My all aluminium radiator from fenix turned up yesterday so now while it is out I am rebooking at fitting the ford AU electric fans to it but make it a far more accurate and neater job than my first attempt

Put some new vents in the wing tops

Extended rear diff breather into passenger cab....last job on the list , Cape York in 5 days

got the semi-floating axles out of the series 1and managed to get the oil seals and bearings out as well what a job, took hours, hmm may need to put full floating axles in the series 1 much easier to change the bearing and diff it if brakes

Mrs hh

High beam fixed. I have the traxride tronics headlight upgrade fitted, I put it in over 5 years ago and never a problem. Still not a problem with the upgrade, just the clown (me) who forgot to put the protective condute (provided in the upgrade kit) over the driving light switch wires from the upgrade relays into the cab and after 5 years it finally wore through causing the short.

Easo

Last week finally got a replacement spare to match the other 4, yesterday fitted new cup holders and replaced rear ones where the kids pulled it from the arm rest. Cleaned the hell out of it. Finished the UHF install and found a good spot to hang the mic (can press button to activate with hands on wheel and talk), added padding and more d/sided tape to base unit under dash & worked out how to change the colors on the face.

Today, new engine mounts, replace radius arms with new QT 3deg HD's, maybe get to steering box. Drill out bar for recovery eyes, fit winch rope, search the streets for money so I can get some new driving lights before heading west. Refit seat covers after dog threw up one one over a year ago (no I washed it, didn't wait the year for it to dry enough to flake off), clean and refit floor mats.

To be done, make template for aux fuel tanks and water tank. Make bash plate for front. Remove rear diff in a day and while it's out get it to Craft to have Ashcoft centre fitted with 4 bolt flange and refit both. While they're doing that, take housing as well to have straightened (2mm tow out on RHS).