Thread: Head removed now what? 300tdi

Originally Posted by Don 130

I read somewhere that you shouldn't run a 300tdi with no thermostat as the back of the head will be drained of coolant causing overheating. Don't know for sure that it's a fact, but I'd be cautious.
Don.

Not ever,you'll destroy the motor within a few K's. Pat

So went to get head tested and found a slight bow between cylinders 2&3 as well as a slight loss I hardness in the same area.
Was informed hardness loss wasn't enough to be worried about on it's own but combined with the slight bow they recommended replacing it.
Now to wait for a new one to arrive and hope that's the end of that issue

How did you go? What type of head did you get? Where did you buy it? I need a new head too! Have you had a price from Hoppers Heads in Melborne, got a great price from them for mine??

Most of the cheap local heads are chinese, not to say that they arent necessarily any good but i wouldnt trust them from a non LR reputable source.

Now the head is off clean the deck within an inch of its life and dry it thoroughly - best advice i got from the knowledge base here.

These are the AMC Heads from Spain, the same ones that Turner's from the UK sell.

Originally Posted by Islandnomad

These are the AMC Heads from Spain, the same ones that Turner's from the UK sell.

Thats good then, seen some chines ones sold locally that i'd be wary of.

I ordered from dls in the UK along with a few other things at a price that leaves anything locally way out of reach.
sure I have heard turners do high quality great heads but my budget really can't stretch that far and locally being quoted $100 just for bolts sounded outages.
Cleaning of the block is on the to do list oil has been drained and filter removed waiting for replacement.
Any tips to remove remaining fluids caught in center of piston or is it best to not install glow plugs and turn engine over by hand.

Originally Posted by Islandnomad

These are the AMC Heads from Spain, the same ones that Turner's from the UK sell.

Ring AMC in Spain and ask where their heads are made, I did, would you believe China, like most replacement heads Cummins, Mack, etc.etc., Regards Frank.