Thread: Abs sensor problems

Back in feels smooth
Just have to get a new lock tab washer, I'm at the limit of reuse

Count the teeth on your after market abs ring does it match the standard count ring teeth.
This has seen some issues with D2`s and after market abs rings with the wrong count of teeth not matching up

Originally Posted by rangieman

Count the teeth on your after market abs ring does it match the standard count ring teeth.
This has seen some issues with D2`s and after market abs rings with the wrong count of teeth not matching up

It was working with the abs ring, the aftermarket part is the sensor.
Thanks for the heads up.
It will have to wait till midweek until I get a lock washer of Mario and use johntins nanocom .
What a great forum

Good to see your looking after my old Defender !!

PS thats not my botch job - Sals was in when I bought it !!

Looks like you're on to something. I'm around pretty much all week, so give me a shout when you want to plug in the nano.

Originally Posted by goingbush

Good to see your looking after my old Defender !!

PS thats not my botch job - Sals was in when I bought it !!

Maybe someone else on here may put their hand up. Re the Sals.

When nanocom will be connected read stationary live inputs from the sensors...they all should be equal between 2 - 2.4V, if the reading of the new one is different than the other 3 even though withing the accepted range the TC will kick in at a time without other reason, unfortunately they made the system too sensotive so any missballance can cause issues

Originally Posted by fitzy

Maybe someone else on here may put their hand up. Re the Sals.

I'm thinking Ivan Clarke