Thread: MXA 5R

Good work AM, I have skills and workshop envy.

MSA-5G clutch
Isuzu P/N 8970234960
Paid $NZ184.42 plus gst approx 2007
21 spline, 28.9mm spline, 275mm OD

Originally Posted by Ancient Mariner

Dougal can`t help with flange
$320 + GST from Isuzu

The Isuzu output flange I have. It's the turned flange mated to it in the picture below that I'd be interested in.

With Grubbs solid shaft and also this flange that Dougal is referring to does the input seal of the lt230 run on the section that would have to be roughly 43mm dia ? Or have there been other ways ?

The seal runs on the raised section between the two splines I made the diam 1.500" to
suit the material on hand so a seal change is required .original od or you could press on a sleeve to suit the original seal

Originally Posted by Ancient Mariner

The seal runs on the raised section between the two splines I made the diam 1.500" to
suit the material on hand so a seal change is required .original od or you could press on a sleeve to suit the original seal

Auh very nice... Never even contemplated changing seals

Has anyone a gearbox that suits the 29mmx21 spline clutch plate available and able to measure the imput shaft for me.The supplier says my shaft is worn
but imput shafts don`t wear on the OD and there is no sign of any so not keen
to order the plate till I can get a proper measurement

Thanks AM

Originally Posted by Ancient Mariner

Has anyone a gearbox that suits the 29mmx21 spline clutch plate available and able to measure the imput shaft for me.The supplier says my shaft is worn
but imput shafts don`t wear on the OD and there is no sign of any so not keen
to order the plate till I can get a proper measurement

Thanks AM

If you can see the machine grooves on the peaks it's not warn...sorry I do not have the box out at the moment though ...