Thread: Suspension - Bilsteins 7100

Originally Posted by mattg

ImageUploadedByTapatalk1441093614.060712.jpg
this what happens with the rte mount without extended bump stops.

Not happy Jan

Tombie must just drive slower. LOL. He doesn't have this problem.

I know there is no way mine would fit without the extended bump stops or taller towers. I have the later now.

At least you just need a couple of parts and some oil and thay'll be as good as new again. You can get all you need from Heasemans if you need. I'm, going to get a different valve stack for the rear from them soon.

Happy Days.

This is only the primary whipper seal no sign of any oil leakage I won't even need to let the gas out. It's the next seal that hold all that in. On second thoughts I might let the gas out to be a bit safer.
Anyone know where to get the gas higher then 150psi? That all I can get from Jax.

Originally Posted by mattg

This is only the primary whipper seal no sign of any oil leakage I won't even need to let the gas out. It's the next seal that hold all that in. On second thoughts I might let the gas out to be a bit safer.
Anyone know where to get the gas higher then 150psi? That all I can get from Jax.

Try a motor cycle shop. They do mine.

I think you'll need to remove the shaft and take off the piston to replace the wiper?

Originally Posted by mattg

ImageUploadedByTapatalk1441093614.060712.jpg
this what happens with the rte mount without extended bump stops.

Not happy Jan

I've got the same RTE mount but added an extended RTE shock turret, result - no contact

Originally Posted by joel0407

Try a motor cycle shop. They do mine.

I think you'll need to remove the shaft and take off the piston to replace the wiper?

Don't the bush ends unscrew?

Originally Posted by Nick S

I've got the same RTE mount but added an extended RTE shock turret, result - no contact

http://www.rte-fab.com/products?page...category_id=12

These the ones?

Yep those are the ones I used but I asked them to make them 50mm taller and it was no problem.
Nick

Anyone tried the factory front lower shock mount http://www.ebay.com.au/itm/301716407018