Photos of the cup holders and my new leather gaiters for gearbox transfer case and handbrake.
Sourced mine from Rovers North
http://www.roversnorth.com/Land-Rover-Parts/376
Cheers, Chris![]()
Bought them over 12 months ago from the US. Googled them up and then followed the links to purchase.
All fitted up. Will take a photo tomorrow.
Remember to measure twice before drilling. I put one hole in the wrong spot. Didn't follow the instructions properly initially and measured both sides up the same way. All good as the cup holder hides the extra hole.
Perfect size to hold your iPhone as well.
My cup holders are grey. They are slightly different colour to my interior trim. To be fair mine is faded. Cup holders are great. Only issue is releasing the handbrake. Make sure you don't jam your finger between the cup holder and the handbrake lever.
Cheers,
Photos of the cup holders and my new leather gaiters for gearbox transfer case and handbrake.
Sourced mine from Rovers North
http://www.roversnorth.com/Land-Rover-Parts/376
Cheers, Chris![]()
They are an odd size,, too big to hold cans, too small to hold a foam stubby cooler.
"How long since you've visited The Good Oil?"
'93 V8 Rossi
'97 to '07. sold.![]()
'01 V8 D2
'06 to 10. written off.
'03 4.6 V8 HSE D2a with Tornado ECM
'10 to '21
'16.5 RRS SDV8
'21 to Infinity and Beyond!
1988 Isuzu Bus. V10 15L NA Diesel
Home is where you park it..
[IMG][/IMG]
I'm suspecting that you drive a well maintained vehicle, correct me if I'm wrong.
I on the other hand, because of need am driving a cheep (there's that little bird again) DIIA that I have just purchased and not had time to go over properly.
Radiator hoses blew up like balloons, air conditioner condensor fins closed over or full of dirt not to mention two big driving lights in front of grille. And speaking of grille, isn't it nice to be able to undo three fasteners and it comes out (DIIA).
Overheating has seemed a problem for this car, it has a huge alloy radiator fitted, I'm told to watch for cracks in solid alloy radiators.
What else I have found out, centre diff does not lock, with it locked I should be able to drive rear wheels only shouldn't I?
I have a 2000 unit, can the nose piece with the diff in it fit 2003?
That's because the double cardan joint is shagged and the shaft is out, so what is the best way to fix this? C/Over, different joint or simply repair the existing.
That might be what I do for the rest of the day, oh, after I fix the BIG fuel leak.
Actually I don't get out of it too badly, I bought the silicone hoses and fuel pressure thingy for the last car and wrote it off before I got around to fitting them!
Cheers
Mike
Took a throttle pedal out of a car that is being dimantled, drove home, took my pedal out, swapped over the orange clip, fitted "new" pedal into mine - test drive all
Ok. Hope my intermittent loss of power problem goes away now..!
![]()
Finally replaced blown interior light bulb with and LED repalcement from JAYCAR,
Replaced all three, nice and bright now inside.
Cheers Chris
"How long since you've visited The Good Oil?"
'93 V8 Rossi
'97 to '07. sold.![]()
'01 V8 D2
'06 to 10. written off.
'03 4.6 V8 HSE D2a with Tornado ECM
'10 to '21
'16.5 RRS SDV8
'21 to Infinity and Beyond!
1988 Isuzu Bus. V10 15L NA Diesel
Home is where you park it..
[IMG][/IMG]
I'm suspecting that you drive a well maintained vehicle, correct me if I'm wrong.
repaired rather than maintained
I on the other hand, because of need am driving a cheep (there's that little bird again) DIIA that I have just purchased and not had time to go over properly.
Radiator hoses blew up like balloons, air conditioner condensor fins closed over or full of dirt not to mention two big driving lights in front of grille. And speaking of grille, isn't it nice to be able to undo three fasteners and it comes out (DIIA).
Overheating has seemed a problem for this car, it has a huge alloy radiator fitted, I'm told to watch for cracks in solid alloy radiators.
Nothing wrong with alloy rads, millions used daily world wide, think yourself lucky you have one
What else I have found out, centre diff does not lock, with it locked I should be able to drive rear wheels only shouldn't I?
I have a 2000 unit, can the nose piece with the diff in it fit 2003?
Should just bolt up? you will need the early linkages, the car is not designed as a RWD so act accordingly--
That's because the double cardan joint is shagged and the shaft is out, so what is the best way to fix this? C/Over, different joint or simply repair the existing.
Do your research. lots of great posts in here about different fixes. Choose one that suits you.
That might be what I do for the rest of the day, oh, after I fix the BIG fuel leak.
Actually I don't get out of it too badly, I bought the silicone hoses and fuel pressure thingy for the last car and wrote it off before I got around to fitting them!
Cheers
Mike
actually Mike my post was a dig at the notion that for a D2 to survive hot weather you must change the layout of the rad hoses.
and it just aint so.
"How long since you've visited The Good Oil?"
'93 V8 Rossi
'97 to '07. sold.![]()
'01 V8 D2
'06 to 10. written off.
'03 4.6 V8 HSE D2a with Tornado ECM
'10 to '21
'16.5 RRS SDV8
'21 to Infinity and Beyond!
1988 Isuzu Bus. V10 15L NA Diesel
Home is where you park it..
[IMG][/IMG]
We got big rain in brisbane today and in normal driving drove through some unexpected puddles.
About an hour later on dry road two amigos came on.
TC and ABS... and the chimes as they did...
Hill descent is not on...two lights only.
Hill descent lights as test with ignition on.
No faults on the OBDC but I know it's a bit lite.
Ideas?
Cheers
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks