Thread: What happened to your Discovery 2 today?

Originally Posted by Roverlord off road spares

Now you can burn rubber and overtake those nasty grey nomads driving LC and towing their big caravans with ease

Yeahh,,, Like he needs more speed,,,

Have you ever had to follow him somewhere,,??? Its like trying to follow Fangio

Originally Posted by Chops

Yeahh,,, Like he needs more speed,,,

Have you ever had to follow him somewhere,,??? Its like trying to follow Fangio

So he's a lead foot is he , he must be so fast that even the speed cameras can't get his pic?
He must have read your earlier post about being messy, I noticed today he was working pretty clean.

Originally Posted by rangieman

Well fitted this today and Wow when it comes on boost it throw`s you back in the seat ,
Just wait till i do a remap once i get one

Would u mind posting a link of what it is & where u got it pls?

Originally Posted by John_D2

Would u mind posting a link of what it is & where u got it pls?

https://www.turborebuild.co.uk/websh...Cartridge.html

Originally Posted by rangieman

https://www.turborebuild.co.uk/websh...Cartridge.html

Thanks. That's tempting

Originally Posted by John_D2

Thanks. That's tempting

Yep. I'm also considering it.....

Originally Posted by rangieman

Well fitted this today and Wow when it comes on boost it throw`s you back in the seat ,
Just wait till i do a remap once i get one

Nice! Just imagine how much better it'd be with an auto!!

Did a fluid and filter change on my TD5 4HP22EH after about 30KK at 189KK.
Pig of a job as you always get fluid everywhere, especially after you take off the sump as it drips from the whole bottom of the trans.
Anyway no lumps in the sump which is good and just slurry on the magnet.

PITA to fill then start up and run through the gears a few times then top up until it runs out.

TIPS? clean off the sump gasket mating surface and clean and lubricate the bolts and clamps. Don't overtighten them or you will break them as per a post recently. I use a 1/4 inch socket to be sure and a spot of superglue to hold each side of the gasket onto the sump flange. You have to hold up the sump with one hand and start the bolts with the other. You need Torx AFAIR a 50, 30 and 25 . One could ask why not the same size for all the bolts. The Sump is held on by 10MM bolts.
I jacked up the RH front corner of the car as I was filling but it didn't seem to make much difference as it still took almost 3 plunger thingos to top up while running, as well as completely coat my arm.

I use Castrol Transmax Z as it is recommended by ZF for Heavy duty use but Exey ( although not by D4 standards LOL) .

Regards Philip A