Thread: What happened to your Discovery 2 today?

I replaced the fuel filler flap clip!
Ordered a new Provent 200

Originally Posted by Slunnie

Check out the Davis Performance ones. They're sealed, so once its done then you can forget about them.

Some potting epoxy can do the trick.

Originally Posted by Tombie

Some potting epoxy can do the trick.

I cant recall if the multistrand is soldered, but they're siliconed up as well.

Originally Posted by Slunnie

Keen to hear what you think of the HDTerrain. I worry that they will be a very stiff riding tyre, but they look like they’d be a good product.

Having now driven on them, they are a little firmer than the old bridgestone duellers that I had on. Tried them down the cobblestones and it was noticeable for the increased patter - not uncomfortable or such, just a bit terser in the ride, luckily this is not my daily driver.

Have included some pics as to the tread which is 'DEEP' and would suggest they are more MT than AT.
20240201_125928.jpg

20240201_125922.jpg


Also replaced the security nuts this time around, it feels good!

photo_2024-02-01_15-16-16.jpg

The weekends job, I think I'll use the starter to get it lose, is the breaker bar to rest on top of the passenger frame rail? will use the holding tool to do it up.

Originally Posted by Four Loko

photo_2024-02-01_15-16-16.jpg

The weekends job, I think I'll use the starter to get it lose, is the breaker bar to rest on top of the passenger frame rail? will use the holding tool to do it up.

Careful the breaker bar doesn't fly off and ruin your whole day.

Originally Posted by Tins

Careful the breaker bar doesn't fly off and ruin your whole day.

Great minds, or fools seldom?

Originally Posted by V8Ian

Great minds, or fools seldom?

Take you pick. But it's why I own a Milwaukee 3/4" drive 18 volt rattler.