Thread: Rhino Backbone

My D3 from the floor to top of the platform is 1970mm at normal height and 1920mm in acess height

Sent from my GT-I9505 using AULRO mobile app

Hi guys
For my roof platform I used rhino tradie bars (3 of them) and had a local security door manufacturer make a "door" to fit less the insect mesh. Bolted it to the bars with 6 mm mush head screws into flat nuts which slide into roof racks
Works really well with light weight and a fraction of the cost of proprietary platforms only adds 25 mm to the height of the bars and gives lots of tie down points to the mesh (even came powder coated in black)

Originally Posted by Bobc163

Hi guys
For my roof platform I used rhino tradie bars (3 of them) and had a local security door manufacturer make a "door" to fit less the insect mesh. Bolted it to the bars with 6 mm mush head screws into flat nuts which slide into roof racks
Works really well with light weight and a fraction of the cost of proprietary platforms only adds 25 mm to the height of the bars and gives lots of tie down points to the mesh (even came powder coated in black)

Sounds good. Any chance of some photos?
David

Have some here on the phone

Hopefully you will be able to see the rack also included a shot of drawers that I made folding solar panels fit under fridge

Can anyone with the backbone let me know how high it sits from the roof at the rear? I have a sunroof at the front and the DAB antenna at the rear. I reckon that I'll need 60mm to clear both items, but the backbone looks lower than that.

I'll throw up some measurements Monday if no ones beaten me to it

Sent from my GT-I9505 using AULRO mobile app

Originally Posted by bakerdavid

Can anyone with the backbone let me know how high it sits from the roof at the rear? I have a sunroof at the front and the DAB antenna at the rear. I reckon that I'll need 60mm to clear both items, but the backbone looks lower than that.

Lowest part of the platform to the roof is 50mm