What happened to your D3/D4 today?

Quote:

---

Originally Posted by loanrangie

I've been planning a storage solution for a while but finally made a start last weekend, originally bought 13m of 13x13/1.8mm SHS but to get the rigidity i needed it wasn't enough.
I cut up an old roofrack that a mate and i went halves in years that was made of 20mm SHS and used that as the base frame then made the top frame and uprights from the 13mm, top only needs to support some camping gear and is more than adequate.
I made a fridge slide years ago from 25mm alloy with plastic connectors and gal rod so i built the frame around it, fridge will be on the right and on the left i'll be making a chuck box style kitchen box from plywood that will be on a slide but fully removable.
https://uploads.tapatalk-cdn.com/202...2fdb935f06.jpghttps://uploads.tapatalk-cdn.com/202...23f6876cb2.jpghttps://uploads.tapatalk-cdn.com/202...340645b671.jpghttps://uploads.tapatalk-cdn.com/202...c2d85c7bfe.jpg

---

This is a nice it of kit

How to build a slide out drawer / DIY / Land Rover Discovery 3 / LR3 LR4 - YouTube

Just trying to keep on top of everything, so while it went in for it's 534,000km service, it had a few things done at the same time.
Replaced faulty tailgate latch
Bought and programmed a spare key
Replaced the worn rear sway bar bushes
Replaced the rear tail shaft as the centre bearing was knackered.

It now drives like a new car again. Going to take it up to Lancelin tomorrow with a few mates so that should clean out the cobwebs!

Quote:

---

Originally Posted by cripesamighty

Just trying to keep on top of everything, so while it went in for it's 534,000km service, it had a few things done at the same time.
Replaced faulty tailgate latch
Bought and programmed a spare key
Replaced the worn rear sway bar bushes
Replaced the rear tail shaft as the centre bearing was knackered.

It now drives like a new car again. Going to take it up to Lancelin tomorrow with a few mates so that should clean out the cobwebs!

---

Sensational!

I see Advanced Factors now offer a complete control arm replacement kit.

Quote:

---

Originally Posted by PerthDisco

This is a nice it of kit

How to build a slide out drawer / DIY / Land Rover Discovery 3 / LR3 LR4 - YouTube

---

Yeah not very practical though.

Did the 3/4" slotted and bolted socket mod onto the spare wheel winder.

Only trouble is that between my 3rd row seats there's not enough room to fit the 1/4" extension bar.

I suppose I could cut out a section of the "offending" plastic covers, but don't plan to.

Does anyone know if the separation between the seats is adjustable enough to slide the extension in between? I never planned to leave the extension in situ, but only to fit and use it as needed.

Quote:

---

Originally Posted by gavinwibrow

Did the 3/4" slotted and bolted socket mod onto the spare wheel winder.

Only trouble is that between my 3rd row seats there's not enough room to fit the 1/4" extension bar.

I suppose I could cut out a section of the "offending" plastic covers, but don't plan to.

Does anyone know if the separation between the seats is adjustable enough to slide the extension in between? I never planned to leave the extension in situ, but only to fit and use it as needed.

---

Just remove the plastic covers…come off quite easily, and you really don’t notice without the covers.

Quote:

---

Originally Posted by PerthDisco

This is a nice it of kit

How to build a slide out drawer / DIY / Land Rover Discovery 3 / LR3 LR4 - YouTube

---

How to build a slide out drawer / DIY / Land Rover Discovery 3 / LR3 LR4 - YouTube

Quote:

---

Originally Posted by stuarth44

How to build a slide out drawer / DIY / Land Rover Discovery 3 / LR3 LR4 - YouTube

---

One large simple full size slide for fridge and variety of stow boxes is quite appealing. Access to the space under for other storage

Towed 3 trailers of concrete and steel to the dump.

Bloody hell it takes a bit to empty by hand!!!
https://uploads.tapatalk-cdn.com/202...c467def0b8.jpg

Quote:

---

Originally Posted by Tombie

Towed 3 trailers of concrete and steel to the dump.

---

I was hoping to see a D4 road train with 3 trailers in tow. Disappointed :(