What happened to your D3/D4 today?

Quote:

---

Originally Posted by l00kin4

Had a week of skiing in Perisher last week. This on Friday

Does anyone know if there is a way to 'park' the wipers vertically ? I found a method which stops them vertically to replace the blades but then goes back to the normal lower position as soon as you turn off the ignition.

---

Apparently not.

Lift wiper when park in snow

Tony

Quote:

---

Originally Posted by eckolsim

Plumbed in the Anderson wiring for my trailer through the rear RHS taillight to my fuse block. Bit of a bugger and noticed I have broken one of the tail light studs. Does anyone know if these are procurable?

Attachment 186652

Good one shown installed, broken laying on side missing top knob. [emoji23] knob! Probably should grow up now. [emoji23] Nup. Snigger.

---

Nope. Not that I’ve found. Come with the light. I ended up using a fat blob of Sikaflex where the plug goes to keep it in place. Worked fine. Shame though.

Quote:

---

Originally Posted by eckolsim

Probably should grow up now. 😂 Nup. Snigger.

---

Growing old is compulsory, growing up is optional. [thumbsupbig]

This one has me on the verge of getting a 3d printer...or am I just searching for excuses for a new toy!

Quote:

---

Originally Posted by eckolsim

This one has me on the verge of getting a 3d printer...or am I just searching for excuses for a new toy!

---

You mean the plug? Yes agree. I have one, but designing something like that takes time. Happy for you to design it and I’ll print it for you [emoji4]

Might be easier to turn one up out of brass rod.

Quote:

---

Originally Posted by DiscoJeffster

You mean the plug? Yes agree. I have one, but designing something like that takes time. Happy for you to design it and I’ll print it for you [emoji4]

---

Thanks mate for the offer. The postage from Perth would kill me though.

Quote:

---

Originally Posted by BradC

Might be easier to turn one up out of brass rod.

---

Mate next door is a tool maker by trade. Maybe could turn something up in nylon.

That could be more fun than a 3d printer.

Quote:

---

Originally Posted by eckolsim

Mate next door is a tool maker by trade. Maybe could turn something up in nylon.

That could be more fun than a 3d printer.

---

Faster and easier too with a neighbour like that. I did my first turning with Acetal (Delrin) last night and that stuff is a dream to work with.

Quote:

---

Originally Posted by eckolsim

Plumbed in the Anderson wiring for my trailer through the rear RHS taillight to my fuse block. Bit of a bugger and noticed I have broken one of the tail light studs. Does anyone know if these are procurable?

Attachment 186652

Good one shown installed, broken laying on side missing top knob. 😂 knob! Probably should grow up now. 😂 Nup. Snigger.

---

A bit of threaded rod or cut down bolt will work.