Thread: What happened to your D3/D4 today?

Originally Posted by eckolsim

Plumbed in the Anderson wiring for my trailer through the rear RHS taillight to my fuse block. Bit of a bugger and noticed I have broken one of the tail light studs. Does anyone know if these are procurable?

Attachment 186652

Good one shown installed, broken laying on side missing top knob. knob! Probably should grow up now. Nup. Snigger.

Nope. Not that I’ve found. Come with the light. I ended up using a fat blob of Sikaflex where the plug goes to keep it in place. Worked fine. Shame though.

Originally Posted by eckolsim

Probably should grow up now. 😂 Nup. Snigger.

Growing old is compulsory, growing up is optional.

This one has me on the verge of getting a 3d printer...or am I just searching for excuses for a new toy!

Originally Posted by eckolsim

This one has me on the verge of getting a 3d printer...or am I just searching for excuses for a new toy!

You mean the plug? Yes agree. I have one, but designing something like that takes time. Happy for you to design it and I’ll print it for you

Might be easier to turn one up out of brass rod.

Originally Posted by DiscoJeffster

You mean the plug? Yes agree. I have one, but designing something like that takes time. Happy for you to design it and I’ll print it for you

Thanks mate for the offer. The postage from Perth would kill me though.

Originally Posted by BradC

Might be easier to turn one up out of brass rod.

Mate next door is a tool maker by trade. Maybe could turn something up in nylon.

That could be more fun than a 3d printer.

Originally Posted by eckolsim

Mate next door is a tool maker by trade. Maybe could turn something up in nylon.

That could be more fun than a 3d printer.

Faster and easier too with a neighbour like that. I did my first turning with Acetal (Delrin) last night and that stuff is a dream to work with.