Thread: D2 Music players?

im running a very similar unit. was plug and play to setup just had to swap the 12v constant power and the accessory power pins with one another and works a charm. located the gps black aerial box on the front left a pillar. the GPS software is on a micro sd card. Im loving the bluetooth compatibility on mine.

on the throne

Originally Posted by OffTrack

It's not a bad looking unit. It appears to be a WinCE device and runs the GPS Nav software from SD Card so it should be possible to run OziExplorer or MemoryMap on it.

This is my second unit (the first unit died a while after the warranty). It uses WinCe.Net. I've tried running a tonne of turn by turn apps, etcetera... Only the Sygic software works with it - and only that particular software from the Eonon company.

I bought OziEplorer for windows and Android: The notebook on the dash runs OziExplorer for Windows. The Android version isn't functioning at the moment due to a lemon-tablet - can't even make lemonade with it.

I'm hopping to test the Android version on a Nexus 7, soon.

Cheers.

Originally Posted by disco_disco

im running a very similar unit. was plug and play to setup just had to swap the 12v constant power and the accessory power pins with one another and works a charm. located the gps black aerial box on the front left a pillar. the GPS software is on a micro sd card. Im loving the bluetooth compatibility on mine.

on the throne

I wonder if that was my problem with the unit resetting itself if I left it running and then try to start the diesel.

A brilliant person here gave me the ISO plug layout. I'll check when I put it in.

Cheers.

the pins are easy to pull out, you just need a small set of screw drivers and push it down the pin end, along the side of the pin and pull on the wire it should come out easy.

Originally Posted by alien

I can't help with the sound of the digital side of things.
It's 60Km to where the network starts in my part of the woods and I don't head that way often in the off road toy.
I may give it go tomorow on the way to camp before our Sunday trip.
The network is due to expand but who knows when.

I feed the digital arial along the heater box using a coathanger to get it through the gaps.
It then runs up under the L/H A pillar trim and is stuck to the windscreen between the pillar and centre mirror.
Watch the pick up wires to the box, one of mine pulled out when fitting.

To remove the old head unit I used some 3 inch nails that fitted just nice into the holes.

Thanks mate. So glovebox out and then up from under for the last bit to feed up the A pillar cover?

Cheers

...also did the little facia cover under the stock unit go back in and look sweet?

Cheers

Hi all,

All done.





Cheers.

Well done mate!

I am very close to an acquisition of a DAB stereo. I pulled out the stock unit this morning and the HVAC and had a poke around...Im not sure how to route the DAB antenna past the back of the glove box. I assume you start on the left side of the stereo area where it drops down and feed it down there somehow?

Cheers