What happened to your Discovery 2 today?

Quote:

---

Originally Posted by Bohica

I'll buy!!

---

You fit that resonator yet, Julian?

Quote:

---

Originally Posted by Slunnie

Here we go, check out the new uninstalled bolt for the steering/key lock - I've never seen bolts like this before. When torqued the top part with the hex snaps off leaving the dome head remaining. The M8x1.25 x12 hex cap screws were just from the local nut and bolt shop. The cap screws are 12.9's rather than 8.8's so a lot stronger than the factory bolts I would expect. I don't think regular bolts will fit the mounts.


Attachment 169354

---

they are shear bolts its to stop car theft by changing the ignition lock LOL

Quote:

---

Originally Posted by Tins;[URL="tel:3069341"

3069341[/URL]]You fit that resonator yet, Julian?

---

Yes, the following Saturday.

Quote:

---

Originally Posted by Tins;[URL="tel:3069340"

3069340[/URL]]I've seen 'em. New ignition locks often come supplied with 'em.

I'm going to try and get down there tomorrow and see how I go getting the old one off....

---

Use a chisel.

Quote:

---

Originally Posted by Bohica

Use a chisel.

---

Someone had been there before me. Flat head screwdriver and it was off in seconds.

My Landrover D2 was born to tow Landcruisers ;) https://uploads.tapatalk-cdn.com/202...e4791775e4.jpg

Quote:

---

Originally Posted by maxperformance

My Landrover D2 was born to tow Landcruisers ;) https://uploads.tapatalk-cdn.com/202...e4791775e4.jpg

---

Shoulda left it where it was[bigsmile1]

Quote:

---

Originally Posted by maxperformance

My Landrover D2 was born to tow Landcruisers ;) https://uploads.tapatalk-cdn.com/202...e4791775e4.jpg

---

Something may have been lost in the transition, but what I think you meant to convey was, Toyota were born to be towed by Land Rovers. [wink11]

For the second time!
Rear sway bar link failed and allowed the ACE pipes to float around resulting in wearing through and leaking.
Fortunately this time driver noticed the red ACE warning light on the dash and we didn't lose all the fluid resulting in a destroyed pump last time.
In the market for some replacement pipes if you have any lying around.

Speedo finally failed for good today.
Formerly it used to work after about 5 minutes of starting from cold, but not anymore.
Also, detected a miss occasionally on number 8 cylinder, so time to install the new leads I bought a while back.
Another fun job. [emoji31]