Thread: What did you do on your Landy today?

Originally Posted by d2dave

Along the way I stabbed my wrist a beauty on the hard plastic overflow pipe that LR kindly cut at a 45 degree angle and I am sure they then sharpened it.

Still got the scar from that one

Getting a load of firewood today, got almost back home and it suddenly lost power. More to the point, the throttle did not seem to do anything.

Failed to climb the last steep bit near the hows in 1st/low, so I ran back onto the level and investigated. Link between the throttle linkage and the carburetter had fallen off the linkage at the ball joint. Put it back on, but this repair must be judged as temporary!

I'll have a look tomorrow and see what I can do, but I suspect it is simply wear.

John

Picked up my baby, and drove her for the first time in 8 weeks

Having driven a little rice burner for the time she was in the shop,,, how many times did I stuff things up for the 50 minute drive home,,???,,,
Stalled her twice,,, kept turning the blinkers on instead of wipers,, and vice-a-versa

"Dont tell me,,, I know boats",,, Woops,, Have to learn to drive her again,, Best be hitting the road

Gave my D2 an oil and filters change. Whilst under the bonnet I thought I would have a look in the injector loom plug. It was full of oil. I then removed the ECU plugs and all was dry but I guess it is only a mater of time.

Replaced the engine and gearbox in the 6cyl ute.

Replaced the carburettor to bellcrank link on the 2a, after it came off yesterday. The spring clips are worn - does anyone know if you can get these clips?

The one I fitted is off an older 2a (one of the "rolling parts supplies" I have), and has adjustable brass ends.

John

Originally Posted by JDNSW

Replaced the carburettor to bellcrank link on the 2a, after it came off yesterday. The spring clips are worn - does anyone know if you can get these clips?

Hi John, I will keep my eye open for the brass one's for you.

Rod assembly, -------------------- Part number 506210 }up to engine suffix 'C'
Ball joint for rod, ( Brass ) ------- Part number 277633 }up to engine suffix 'C'

Control rod, bell crank to carburetter, Part number 531439 }from engine suffix 'D'
Ball joint, -------------------------- Part number 531324 }from engine suffix 'D'
.

Had use of my mates hoist and his assistance, removed cat and centre silencer. Got the cat out whole by removing the the crossmember with a BFG. Any how was quite surprised by the almost total lack of increased noise, going to test on Saturday with a little 1500k run. My hope that it's effectively increased the fuel tank range by about a @gallon and a half. next thing to install the chip tech intercooler !