Thread: What did you do on your Landy today?

Fitted the first ever set of APT Sliders to my D4..
Been hounding Ben to make D3/D4 stuff for months and he has delivered...
Attachment 79861

Attachment 79862

Attachment 79863

Attachment 79864

Forgive the Hex Bolts, I'm still waiting on my Button Head bolts to arrive and will switch them over then.

Tonight I removed the front drivers door trim to find out why the window only went up 3/4 of the way before jamming on something .
I discovered that the bottom rail is bent and twisted on the window runner.

I have never seen this on a car before !

Photo attached !

I think

Fairly common. I bent up new ones to match and siliconed the glass in ..change the scissor lift rollers while there ..replacement from hardware..I.e sliding door rollers

Fitted HID Hi/low head light inserts.
Very impressed with the results.
Took a little longer to install than last vehicle due to the battery location.

Tested it last night with no oncoming traffic flashing me, so thats a good thing. There is a clean cut line of light low on the road. no big flash of light that i have experienced from other installs. high beam light is awesome.

Cheers
David

Originally Posted by Witchdoctor

Fitted HID Hi/low head light inserts.
Very impressed with the results.
Took a little longer to install than last vehicle due to the battery location.

Tested it last night with no oncoming traffic flashing me, so thats a good thing. There is a clean cut line of light low on the road. no big flash of light that i have experienced from other installs. high beam light is awesome.

Cheers
David

Which units did you use David?

uploadfromtaptalk1404642672960.jpguploadfromtaptalk1404642718960.jpgPut a hella plug and marine cig lighter plug in the rear of my d2 for my fridge etc and wired it all my 6mm cable down to then engine fuse box take off points. Love working on the reverse tardis...so much room between inner and outer skins for wiring.

Cheers

Chops

I imported a set from China, no brand on them

David

Got all the cabling run through the glands and also got the Exbox built up component wise. I have 6 glands on the battery box now for power feeds out to the winch, neg, alternator and to the ex box - just have to crimp them up and finish with the exbox.

Also got the rear diff back in. The pattern looks perfectly centered on the teeth however the backlash is .43mm which is roughly double what it should be from the specs. The vehicle is having a Eaton E-locker put in and a complete rebuild at the same time in the next 3-6 weeks so I am not too worried. Essentially, the diff will only be needed to get the vehicle into the shop for the work.