There are two places that it rubs through.
The original place was just at the first bend from the fuel pump as the main engine line turns right to run across the top of the crossmember.
Mine was different as maybe when they did the original recall ( if it was done) the mechanic did not secure the redundant harness for AFAIK the height sensor on the RH side.
This sat on my high pressure line and wore a hole through just at the right angle turn of the line on the RH corner of the tank where it leaves the crossmember to meet the inside of the chassis.
When I replaced the whole manifold the mechanic wrapped the high pressure line in thick rubber tape.
Regards Philip A



Reply With Quote


Bookmarks