Thread: Gilbert

Holden has nine teeth on starter.
If the ones that forward throw are made for a series then they should be correct and engage on the ring gear without any problems. The only thing is a two and a quarter ring gear only has a leading edge on one side.


Cheers, Mick.

Thanks for the reply.
NEW Seats, just a little work

whitehillbilly

Plus Zenith Carbies.
One has had a kit through it.
Rubber tipped Needle and new seat.
water has been it one of them for a white.
One has a 125 main, the other a 120 main jet.
Bit of wear on the throttle shaft, but I know a man with a lathe.

whitehillbilly

Two different idle screws.

Just a question about exhaust/inlet gaskets.
Two arrived in the kit.
One full length, the other 2, double hole alloy inlet gaskets.
What is the idea of the two ????
does the later one rely on a metal to metal seal on the exhaust side ????
Which fits which motor
Thanks

whitehillbilly

Small packet of parts from these guys.
Very helpful, parts arrived quickly.
Front mud plate, and starter dog lock washer.

John Richards Surplus Ex-Military and General Surplus

Timing gear done, new parts fitted,
10 thou between chain and slipper.
Doesnt quite go onto the next tooth, but read somewhere, don't force it, just leave it where it wants to sit, and it will sort its self out as the chain beds in a bit ????
200 lbs on the starter dog. Why so tight ????
Thanks.

whitehillbilly

Well a few choices of wheels.
2 on left, 58 is the only no I can find.
4 on right, only 2 may be ok, rust around valve stems.
One not shown, original on bonnet.
Will be shod in 235/85/16's I think.

whitehillbilly