Thread: What happened to your Discovery 2 today?

Originally Posted by clintooo

technically, I haven't done it yet (job for tonight). But these turned up at work this morning. I'd been looking for a black set for ages and they popped up on ebay.



cup 2.jpgcup holder.jpg

Did the instructions come with them??
I've a copy If you need it??
Just be careful drilling the holes for the mounting screws as the air duct is directly under the mounting locations!!

no they didn't.

It would be much appreciated if you could. I'll PM you with my email.

cheers

Clint

Originally Posted by Lemo

Did the instructions come with them??
I've a copy If you need it??
Just be careful drilling the holes for the mounting screws as the air duct is directly under the mounting locations!!

That`s fine as it will work as a coffee warmer in winter and a drink cooler in summer

Originally Posted by John_D2

New cam plug to fix a new oil leak. Only 99 leaks to go!

I've got 99 leaks but a cam ain't one...

Originally Posted by clintooo

no they didn't.

It would be much appreciated if you could. I'll PM you with my email.

cheers

Clint

Originally Posted by John_D2

New cam plug to fix a new oil leak. Only 99 leaks to go!

Min needs doing how hard they to do mate

Finally inserted my spare engine in my spare D2. I may never walk straight again and my ears are still ringing to the sound of the socket dropping to the bottom of the bell housing and the bastard coolant pipe at the rear that got wedged, but otherwise all good so far. I'll fire it up in the next few days with my fingers crossed of course.
Nick

Originally Posted by Mclaren00

Min needs doing how hard they to do mate

5 seconds to remove old 1 with screwdriver. 1 min to apply black goop (same stuff I used on rocker cover gasket) to new plug. 30 seconds to push plug into hole.

Longest part was removing old goop/sealer with fingers followed by dry wrag, then turps and lastly metho.

Super easy job.

Had to remove a wire that was bolted with 2 bolts in front of plug. That probably took longer. If u do remove the wire watch out for the spring clip on the connector. It's easy to loose.