Thread: What did you do on your Landy today?

Originally Posted by 460cixy

Where the hell did you get that?

Honestly don't know. My wife gave me him about 20 years ago & he has always lived on my office desk until I retired. Found him in the shed when I was looking for the replacement coil. He now lives on the dash?

dropped the disco in to get the head gasket done... cross your fingers for me everyone!

New water pump fitted bearing failed on the old one

Finally got round to fitting the front bar on my D1. Still have to service & fit the winch and fabricate a front tow hitch receiver.

Thanks sheerluck (one word )

Originally Posted by pop058

Finally got round to fitting the front bar on my D1. Still have to service & fit the winch and fabricate a front tow hitch receiver.

Thanks sheerluck (one word )

Looks good Paul! I had one that looked just like that.....

Are you going to turn the gearbox around on the winch?

Oil and filter flush oil cooler with fresh oil (200tdi).
Fix park brake that has not worked since i replaced the transfer
output seal a few weeks ago, seems i put the expander pistons in backwards.
works real well now.

Have new t/fer and handbrake boots, new wiper motor and wiper blades
for sIIa to go no soon.

Andrew

93 tdi200 Disco
65 88" sIIa.

Started yesterday on a straight forward job of replacing the kick down cable on my auto 300tdi 110 as the injector pump end was frayed and do a filter change and fluid flush at the same time[mid arvo], whilst undoing the valve body my t27 torx bit snaps and pannick sets in, had to buy a set at supercrap as t25 & t30 are common but not t27. Next i had to chisel out the damaged bolt but no dramas as i have a spare zf in pieces, then install kick down cable into box, mate turns up, sump and filter on and finish off on Sunday morn. Sunday morn while attempting to conect new kickdown cable to pump i discover its 80cm long unlike the 102cm it is to replace-it does not reach and my guess is that it is for a v8 and not a 300tdi? Ring a mate who borrowed the kick down off my spare auto befor cooking his auto and borrow back my own part! sump/filter and valve body off again to install correct length but used cable then dissconnect the cooler and flush the box.
What a huge difference to drive now- I guess i had just worn in with the frayed stiff cable.
Alls good

got the leather heated seats working